Stay Current

Ran input shaping and the wavy wall's still there? It might not be ringing. Here's how to tell ringing apart from VFA, Z-banding, and salmon skin — and fix the one you actually have.

Why high-speed printing looks worse after all your calibrations — and the one number you need to fix it. Learn how volumetric flow rate limits your hotend, how to calculate your ceiling, and which upgrades actually move the needle.

Your extruder starts clicking four hours into a long print, the nozzle pulls clean, and you spend the next week drying filament that wasn't wet to begin with. Heat creep is the most misdiagnosed failure mode on consumer FDM printers — and the fix is a five-step ladder, cheapest first.

Stringing, blobs, weak layers, popping sounds from the hotend — you've adjusted retraction, swapped the nozzle, and re-leveled the bed. The real culprit is almost always sitting on your spool. This guide covers how moisture gets into filament, how to diagnose it by material, and how to actually fix it — including where PCTG fits in as one of the most storage-forgiving engineering materials available.

Getting the pucks on the wall is the easy part. Getting them dialed in — the right brightness for a 2am hallway trip, the right color temperature that doesn't look harsh, the motion sensitivity that triggers when you need it and stays quiet when you don't — that's where most people just guess. This is what actually works. [Read the Full Guide →]

I moved into a new house and immediately had two spots that made me nervous at night — a staircase and a long hallway, both completely dark. I looked into the full smart home build. The Raspberry Pi route, the Philips Hue ecosystem, the professional install. Then I found a simpler answer that solved the actual problem without any of it. [Read the Full Guide →]